DBAP5 Controller Jumper Settings
JP1: Sync Input Type Select; Pos. 1-2 = Blackburst/Tri-Level Pos. 2-3 CSync
Update July 2022: We have switched the JP1 factory default setting to Pos. 1-2 due to Tri-Level sync being more commonly used. The factory default setting before July 2022 was Pos2-3.
JP2: Serial Comm. RCV_TTL to UART Select; Pos. 1-2 RS232, Pos. 2-3 RS422
JP3: Show Control Port TX Select; Pos. 1-2 RS232, Pos. 2-3 RS422
JP4: Show Control Port RX Select; Pos. 1-2 RS232, Pos. 2-3 RS422
Note: For Jumper J2, J3, and J4, RS422 was never implemented, so jumpers should always be in Pos1-2. Default from factory is Pos1-2.
W1: 75Ohm Sync Termination; On – terminated, Off - Open
Note: W1's factory default setting is on (installed)